HomeAbout UsDistributorsContact
  • Home
  • About Us
  • Distributors
  • Contact

UltraSpart™ 100 Polyaspartic Floor Coating

UltraSpart™ 100 is a two-component, low VOC, aliphatic polyaspartic coating designed as a UV stable topcoat for polyurea and polyurethane systems, or as a standalone rapid return to service system over properly prepared substrates.

Description

It is colour stable and non-yellowing, exhibiting excellent UV resistance. It is available in a range of colours and typically used in:

  • Light to severe industrial
  • Domestic projects
  • Commercial projects
  • Seamless flake flooring
  • UV resistant top coat

Material

Polyaspartic

Advantages

  • High solids
  • UV stable (aliphatic)
  • Rapid return to service
  • Low VOC
  • Excellent chemical resistance
  • Excellent abrasion and impact resistance
  • Excellent adhesion to metal and concrete

Industries

Construction, Concrete Repair, Industrial & Mining

Applications

Mixed material should be poured out in ribbons across the area to be rolled. A 270mm microfibre 5mm NAP roller cover is recommended. The roller should be rolled dry every 10-18m2 to prevent the roller becoming tacky and increase the rollers life. Do not excessively overwork the coating. It is important to back-roll to ensure even application and to break any balloons than may have formed from pinholes. Replace roller cover every 50-90m2. To achieve a non-slip finish, colour chip or flake floor, refer to the relevant Fortis technical bulletin

Surfaces

Substrates should be thoroughly sanded or ground to provide a keyed surface. If applying over existing coatings adhesion should be tested by preparation of a small test area. Remove all potential contaminants. On new concrete surfaces it is best to diamond grind the surface. Old surfaces are best diamond ground but it is possible to etch and clean the surface. Conctact Fortis if unsure. New concrete must be cured for a minimum of 28 days prior to application.

Feature
Specification
Mix ratio
1 parts A to 1 part B (vol)
Volume solids
95%
VOC content
<50 g/L
Application temperature
-10 to +35ºC
Work time
15-20 minutes
Coverage Rate
5m2 /L
Recoat
2-24hrs
Tack free
1 to 2 hours
Light foot traffic
3-5 hours
Return to service
24 hours
Final Cure:
7 Days
Pack Sizes

8L and 20L kits