HomeAbout UsDistributorsContact
  • Home
  • About Us
  • Distributors
  • Contact

Epoxy Primer - Fortis Prime 823

A fast cure solvent-based epoxy primer for concrete substrates before application of topcoats including flake floor.

Fortis 823 Primer over factory

Description

FORTIS PRIME 823 is a solvent-based two-component epoxy primer providing excellent adhesion to porous substrates. The low viscosity ensures deep penetration and superior coverage whilst allowing for quick reapplication of topcoats.  This product exhibits both organic and inorganic reactivity, allowing the epoxy to chemically react with inorganic substrates, giving enhanced adhesion characteristics

Material

2 Component Epoxy

Advantages

• Excellent substrate wetting
• Superior Coverage
• Fast film cure time
• Chemically bonds to siliceous material
• Good low-temperature cure
• Blush resistant

Industries

Construction, Automotive & Marine, Concrete, Industrial & Mining

Applications

Fortis PRIME 823 can be applied is best applied by roller. It can be also be applied by airless spray systems as long as all safety precautions have been taken. Mixed material should be poured out in ribbons across the area to be rolled. A microfibre 5-8mm NAP roller cover is recommended. For porous substrates, multiple wet on wet applications may be necessary.

MIXING

Ensure Fortis PRIME 823 Part A and B are shaken before pouring and mixing. The mixing ratio for Fortis PRIME 823 is 1 Part Resin (Part A) to 1 Part Hardener (Part B) by volume; graduated plastic mixing containers are recommended for measuring volumetric quantities. Part B is to be added to Part A and mixed at low speed with a Jiffy style mechanical mixer. Mix only enough material for immediate use. Mix until a smooth and homogeneous mixture is formed, free of striations. This should take approximately 1 minute. Ensure material from the bottom and edges of the pail are sufficiently mixed. Let material stand for 1 minute. Mix for an additional minute.

Surfaces

Concrete: Substrates should be clean and free of loose material, old coatings, curing membranes, oils, and grease. If applying over existing coatings adhesion should be tested by preparation of a small test area. Remove all potential contaminants. On new concrete surfaces, it is best to diamond grind the surface. Old surfaces are best diamond ground but it is possible to etch and clean the surface. Contact Fortis if unsure. New concrete must be cured for a minimum of 28 days before the application.
Feature
Specification
Pack Sizes

8L
40L