Home About Us Distributors Contact

Spray Adhesive For Polystyrene - Fortis AD211-PS

FORTIS AD211-PS is a high tack solvent-based contact adhesive. FORTIS AD211-PS offers high initial grab and has been formulated for use in the bonding of polystyrene and other lightweight insulation materials.


FORTIS AD211-PS is a high tack solvent-based contact adhesive with excellent substrate wetting. Suitable for Rapid lamination. Extremely high adhesion. Suitable for metal to polystyrene


Polychloroprene Rubber Adhesive


Sprayable Fast drying Excellent green strength Polystyrene foam safe


Construction, Truck, Bus & RV, Automotive & Marine, Industrial & Mining, Craft & Hobby, Shop Fit Out


Spray apply evenly to both surfaces that are to be bonded. Allow adhesive to evaporate until it is no longer wet to touch (~5 minutes). Join surfaces together before the end of the adhesive open time (~5-10 minutes). Apply as much pressure as possible to achieve the optimum bond strength. Fortis recommend that applicators carry out their adhesion test on their particular substrate before application. Fortis AD211-PS should not be applied at temperatures below 10°C. If applying to wood, the moisture of 8-10% and relative humidity of 60-70% are ideal application conditions. Final bond strength is achieved in 24 hours.


LIMITATIONS Coverage rate, open time, and press time are largely dependent on the type of material to be bonded, as well as the ambient conditions. Do not use below 10°C as condensed water may form on the adhesive film and prevent bonding.


Ensure the bonded surface is clean and free from dust, oil, and other foreign materials. Metal surfaces should be degreased with Fortis Sol-T Cleaner.


Yellow or Red
Evaporation time:
5 mins @ 20°C
Open time
5-10 mins @ 20°C
Processing temperature
+10 to +35 degrees
Temperature resistance
-40°C to +55°C

Pack Sizes

20L, 200L


Technical Datasheets

Fortis AD211-PS Technical Data Sheet

Safety Datasheets

Fortis AD211-PS Safety Data Sheet