Concrete Shield™ AcrylaSeal Concrete Sealer is a fast-drying water-based acrylic concrete sealer. Recommended for use on concrete driveways and for sealing factory floors. Suitable for untreated concrete driveways and pavement, including coloured concrete, exposed aggregate, and pattern pave.
Information | Applications | Specifications | Downloads
Concrete Shield™ AcrylaSeal is an acrylic sealer known for its rapid drying and clear finish. It not only enhances aesthetics but also forms a glossy, wet-look film, effectively protecting concrete from oil, grease and dust. Boasting excellent wear resistance and protectiton against weathering it it the go-to choice sealer. Elevate the durability and visual appeal of your concrete with the unparalleled performance of AcrylaSeal.
Water-Based Acrylic Hybrid
Low Odour, Eco-friendly VOC free Fast Drying, Easy to apply Excellent adhesionWater-basedNon-yellowing, Clear Gloss finish Wet-look, enhances the natural colours of the substrate Resistant to oil, grease, dust and dirt Can be used internally or externally for domestic, commercial or light industrial applications Excellent durability
Construction, Concrete, Shop Fit Out
Apply a thin uniform layer of AcrylaSeal with a lamb's wool applicator or 10mm Nap roller. Allow 2 hours drying time (25C & 65% humidity) or wait until the entire area is touch dry before application of additional coats. Avoid applying the sealer too thick. Do not allow any pooling to occur. It takes 24 to 72 hours for full cure. Avoid any foot traffic for 6 - 8 hours after application.
When using AcrylaSeal for the first time always test a small inconspicuous area to ensure the desired result. The surface must be dry and clean before application of the sealer. Only apply if the ambient temperature is above 10C and below 35C.
15L
Fortis Acryla Seal Technical Data Sheet
Fortis Acryla Seal Safety Data Sheet
Refer to Resources
