Concrete Shield™ Natural Look Enhancer is a penetrating sealer and finishing treatment for polished concrete. Applied during the final stages of the concrete polishing process, it helps repel water, oil and grease while enhancing the natural colour and appearance of the floor without forming a conventional topical coating.
Information | Applications | Specifications | Downloads | FAQs
Concrete Shield™ Natural Look Enhancer is a penetrating sealer and finishing treatment designed primarily for polished concrete floors.
Typically applied during the final stages of the concrete polishing process, its fluorinated polymer technology penetrates the prepared surface and helps reduce the absorption of water, oils and grease. Unlike conventional film-forming sealers, Natural Look Enhancer works within the surface while maintaining the appearance and character of polished concrete.
The treatment enhances the natural colour of the concrete and helps produce an attractive, easy-to-maintain polished surface without creating a heavy topical coating.
Natural Look Enhancer complements the Concrete Shield™ polished concrete system following grinding, grouting, densification and polishing. It can be used with Concrete Shield™ Grout 1000, Potassium/Lithium Densifier and Premium Lithium Densifier as part of a complete polished concrete process.
Natural Look Enhancer can also be used on suitable absorbent terrazzo, terracotta and natural or artificial stone where water and oil repellency with a natural appearance is required.
Silicone modified polymers
Designed for polished concrete floors
Ideal as a final penetrating treatment in polished concrete systemsPenetrating water and oil repellentHelps reduce absorption of water, oil and greaseEnhances the natural colour and appearance of concreteMaintains a natural polished-concrete finishDoes not form a conventional topical coatingHelps make treated surfaces easier to maintainSuitable for interior and exterior applicationsAlso suitable for absorbent terrazzo, terracotta and stoneNon-flammable formulation
Construction Adhesives, Coatings & Waterproofing, Concrete Protection
Concrete Shield™ Natural Look Enhancer is typically applied during the final stages of the concrete polishing process after grinding, grouting, densification and polishing have been completed.
Ensure the polished concrete is clean, dry and free from grinding residue, dust, oils or other contaminants. The surface must remain sufficiently absorbent for the treatment to penetrate.
Apply Natural Look Enhancer evenly at the recommended coverage rate. Avoid allowing excess product to dry on the surface. Always test a small area before application to confirm absorption and the final appearance.
Follow the application rates, working times and curing requirements below.
Primarily designed for polished concrete floors as a penetrating finishing and protection treatment.
Also suitable for absorbent:
The surface must be clean, dry and sufficiently absorbent to allow penetration. Previously sealed, coated or non-absorbent surfaces may prevent correct penetration and should be tested before application.
Always test a small inconspicuous area to confirm absorption, compatibility and final appearance.
5L
It provides a final penetrating treatment that helps repel water, oil and grease while enhancing the natural colour and appearance of polished concrete.
It is typically applied during the final stages of the concrete polishing process after the required grinding, grouting, densification and polishing steps.
No. It penetrates into a suitable absorbent surface rather than forming a conventional film or heavy topical coating.
It enhances the natural colour and character of concrete while retaining a natural-looking polished finish.
Yes. Its fluorinated polymer technology helps reduce the absorption of water, oils and grease into suitable porous surfaces.
Coverage is approximately 4–40 m²/L depending on surface porosity and absorption.
Yes. It can also be used on suitable absorbent terrazzo, terracotta and natural or artificial stone. Always test before application.
Yes. It is suitable for interior and exterior absorbent mineral surfaces when correctly applied.
Concrete Shield™ Natural Look Technical Data Sheet
Concrete Shield™ Natural Look Safety Data Sheet
Refer to Resources
