HomeAbout UsDistributorsContact
  • Home
  • About Us
  • Distributors
  • Contact

Concrete Shield™ AcrylaPave Paving Sealer

Concrete Shield™ AcrylaPave Paving Sealer – Fast drying acrylic driveway and paving sealer Is a premium grade fast drying water based acrylic driveway and paving sealer. It provides a protective gloss ‘wet-look’ layer which provides resistance to oil, grease, dust and dirt.


  • Fast Drying, Easy to apply
  • Water based
  • Non-yellowing gloss finish
  • Wet-look, enhances the natural colours of the substrate
  • Resistant to oil, grease, dust and dirt
  • Eco Friendly, Low odour


Water Based Acrylic Hybrid


  • Low Odour
  • Eco friendly
  • VOC free
  • Fast drying
  • Easy to apply
  • Non-yellowing
  • Clear gloss finish
  • Wet-look
  • Excellent durability


Construction, Concrete Repair, Shop Fit Out


Apply a thin uniform layer of Acryla Seal with a lamb’s wool applicator or roller brush. Allow 2 hours drying time (25°C & 65% humidity) or wait until the entire area is touch dry before application of additional coats. Apply subsequent coats in the same manner and if preferred machine buff after applying the 3rd or 4th coats ensuring the surface has had at least 4 hours to dry. A minimum of 2 coats are recommended. Ensure sealer is not applied too thick and is applied evenly. Do not allow any pooling to occur. Full cure is achieved after 24–72 hours. Avoid any foot traffic for 6–8 hours after application.


When using Acryla Pave for the first time, or on a new floor always test a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Make sure surface is clean, free of waxes, coatings, and previous sealers, and is dry for 24 hours. Clean surface with minimum 2000psi pressure washing. Heavily solid/dirty surfaces will require a light acid clean such as 20:1 mix of HCl diluted in water. Mix 20parts water with 1part HCl. Rinse well after cleaning and allow 24hrs drying time before application of the Acryla Seal. Surface temperature should be between 10°C and 35°C. Ensure that the area is well-ventilated during cleaning & application and until the surface is dry.

Opaque liquid (Dries Clear)
Application temperature
10 to 35°C
10-15 m2/L
Pack Sizes