HomeAbout UsDistributorsContact
  • Home
  • About Us
  • Distributors
  • Contact

Concrete Shield™ AcrylaPolish

Concrete Shield™ AcrylaPolish is a premium grade fast drying water based acrylic polyurethane sealer/polish. It provides a highly durable and protective gloss ‘wet-look’ layer leaving the concrete substrate resistant to oil, grease, dust, dirt and is ultra-durable from wear in high traffic areas.

Description

Concrete Shield™ AcrylaPolish can be used for Terrazzo, burnished & polished internal floors. It can also be used as a refresh coat to Concrete Shield™ Acryla Seal.

Material

Water Based Acylic Urethane

Advantages

  • Low Odour
  • Eco friendly
  • VOC free
  • High Solids
  • Easily buffed
  • Non-yellowing
  • Clear gloss finish
  • Wet-look
  • Excellent durability free

Industries

Construction, Concrete Repair, Shop Fit Out

Applications

Apply a thin uniform layer of Acryla Polish with a lambs wool applicator or roller brush. Allow 2 hours drying time (25°C / 65% humidity) or wait until the entire area is touch dry before application of additional coats. Apply subsequent coats in the same manner and if preferred machine buff after applying the 3rd or 4th coats ensuring the floor has had at least 4 hours to dry. Recommended between 4 - 6 thin coats on high traffic areas and 2 - 4 coats in low traffic areas. For optimum results after 4 hours and before 24 hours you should thoroughly burnish the floor with a high-speed polisher (Poli-vac or similar) using a hard high speed animal hair pad. Ensure sealer is not applied too thick and is applied evenly. Do not allow any pooling to occur. Full cure is achieved after 24-72 hours. Avoid any foot traffic for 6-8 hours after application.

Surfaces

When using Acryla Polish for the first time, or on a new floor always test a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Make sure surface is clean, free of waxes, coatings, and previous sealers, and is dry for 24 hours. Clean surface with minimum 2000psi pressure washing. Heavily solid/dirty surfaces will require a light acid clean such as 20:1 mix of HCl diluted in water. Mix 20parts water with 1part HCl. Rinse well after cleaning and allow 24hrs drying time before application of the Acryla Polish. Surface temperature should be between 10°C and 35°C. Ensure that the area is well-ventilated during cleaning & application and until the surface is dry.

Feature
Specification
Color
Opaque liquid (Dries Clear)
Application temperature
10 to 35°C
Coverage
20-40 m2 / L
pH
8.0-9.5
Pack Sizes

5L
15L

Technical Datasheets

Fortis Acryla Polish Technical Data Sheet

Safety Datasheets

Fortis Acryla Polish Safety Data Sheet

Resources

Refer to Resources