HomeAbout UsDistributorsContact
  • Home
  • About Us
  • Distributors
  • Contact

Concrete Shield™ Wet Look Enhancer

Concrete Shield™ Wet Look Enhancer is a ready to use penetrating water and oil repellent based on blended fluorinated polymers in a non flammable solvent. It has an unusual property in that it dries provided a wet look on concrete or stone.


Concrete Shield™ Wet Look Enhancer is a penetrating sealer. This non-flammable, solvent based system is suitable for interior and exterior use. It is used in warehouses, restaurants, retail shops and car parks. In addition to protection of the surface, Concrete Shield™ Wet Look Enhancer lightly darkens the concrete producing a visible lustre. It penetrates deeply and reduces capillary absorbency of water, oils and greases. It is typically used on concrete, ceramics, terracotta, all natural and artificial stones and terrazzo style materials


Fluorinated polymers


  • Wet Look appearance
  • Maximum protection
  • Enhances concrete and stone
  • Keeps polished concrete cleaner longer
  • Non-Flammable


Construction, Concrete Repair


Always test this product in an inconspicuous area prior to application. The surface to be treated must be completely dry, clean and free of stains. Apply evenly with a micro fibre mop or lamb wool applicator (Approximately 40 square meters per litre). The surface should have a uniform shine and wetness. Repeat this procedure with a second application within 20 minutes. After a further 20 minutes lightly wipe off excess product residues with a cloth slightly damp with Concrete Shield™ Wet Look Enhancer to remove puddles, drips etc. Remove residue once surface is touch dry, with a medium stripper / buffing pad. Excessive application will make it difficult to remove.


Ensure all surfaces are clean of oils and dust prior to application. NOTES: Some stones absorb unevenly which may result in a cloudy/patchy appearance. Glass, polishes, plastics, varnish and other surfaces sensitive to solvents must be protected against splashes. Non absorbent and wet surfaces can not be impregnated. Marble and limestone remain sensitive to acid. Drying time: Most of the solvents evaporate within two hours. Floors can be walked on after 12 hours. The impregnator is fully effective after 48 hours. Application temperature: The temperature of the surface to be treated should be between 10°C and 25°C. Turn down under floor heating. Avoid direct sunlight. Coverage: the coverage depends on the absorbency of the surface.

Clear to Amber
Pack Sizes