Excellent polyurethane for a multitude of bonding substrates, from timber, veneers, FRP, Fibreglass and Composite Laminating Adhesive
Information | Applications | Specifications | Downloads
Excellent open time and enhanced penetration for laminating composites such as FRP to timber. Usable through a large range of adhesive applicators.
Polyurethane
100% Solids - suitable for many assembly applications Zero VOC / Solvent and formaldehyde-free 60min Working time 180min clamp time @25C Glues almost anything Paintable / Stainable Sandable Expands as it driesWater-resistantSuperior adhesion Excellent heat resistance
Construction, Truck, Bus & RV, Automotive & Marine, Furniture & Woodworking, Craft & Hobby, Shop Fit Out
Fortis AD5405 requires atmospheric moisture to cure. Ensure some moisture is available in the substrate, typically up to 12% moisture content in timbers and 8% in cement fibre. If substrates are drier it is recommended to lightly mist or wipe the surface with water. One surface should be porous. This is a non-structural adhesive. For structural applications please contact Fortis adhesives & Coatings.
Ensure the bonded surface is clean and dust-free. To achieve optimum bonding results, please ensure a tight-fitting joint, less than 0.3mm is recommended. Excellent substrate-to-substrate contact is necessary to achieve optimum bond strength. A light water mist may be applied to the substrate if no moisture is present to allow cure. Normal clamping time is 180-240 minutes.
LIMITATIONS. Does not adhere polyethene or polypropylene plastic
550g, 5kg, 18kg, 220kg
Fortis AD5405 Technical Data Sheet
Fortis AD5405 Safety Data Sheet AUS GHS
